Please note that you only have 5 attempts to pass this Quiz.
0 of 8 Questions completed
Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 8 Questions answered correctly
Your time:
Time has elapsed
Unfortunately, you did not pass the quiz.
Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
Congratulations, you have passed the quiz!
You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
Congratulations, you have passed the quiz!
You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
Congratulations, you have passed the quiz!
You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
Congratulations you have passed the quiz!
You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.
The FDE solver formulates Maxwell’s equation into a matrix eigenvalue problem. What are the direct results of the calculation?
For a lossy waveguide, how is the modal loss obtained?
When calculating the power coupling, we assume:
The FDE solver can be used to find modes in waveguides with tapers.
The overlap calculation takes into account the fact that some of the fields are reflected.
What input(s) are used by the FDE solver to calculate the modes at a single frequency point?
Does the bent waveguide solver find modes for an infinite bend, or 90 degree bend?
You have a waveguide setup as below for a bent waveguide calculation. The ‘orientation’ is set to ‘0’.
What is the minimum 'bend radius' required in micron?
(Round the answer to first decimal figure, for example, 1.3)