Course Assessment — ETM Using Ansys Maxwell and Icepak

0 of 9 Questions answered correctly

Your time:

You have reached 0 of 0 point(s), (0)

Unfortunately, you did not pass the quiz.

Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
Congratulations, you have passed the quiz!

You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
Congratulations, you have passed the quiz!

You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
Congratulations, you have passed the quiz!

You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
Congratulations you have passed the quiz!

You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.