Course Assessment - Connecting Parts Together
Quiz Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
-
Unfortunately, you did not pass the quiz.
Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
-
Congratulations, you have passed the quiz!
You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
-
Congratulations, you have passed the quiz!
You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
-
Congratulations, you have passed the quiz!
You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
-
Congratulations you have passed the quiz!
You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
Which of these methods are preferred when there exist parts in an assembly that may separate or slide with respect to each other. Select the best option.
CorrectIncorrect -
Question 2 of 10
2. Question
Consider a solid model assembly with many independent parts that are touching. Select the 3 best options that are correct.
CorrectIncorrect -
Question 3 of 10
3. Question
In Ansys Mechanical, the Multi-Point Constraint (MPC) formulation is only available for which of these two contact types? Select the two best options.
CorrectIncorrect -
Question 4 of 10
4. Question
The interaction between gear teeth in a gear assembly can be accurately simulated using which contact type? Select the best option.
CorrectIncorrect -
Question 5 of 10
5. Question
In the Initial Information of the Contact Tool in Ansys Mechanical, what do gray-highlighted contacts signify? Select the best option.
CorrectIncorrect -
Question 6 of 10
6. Question
When using the Contact Tool to generate Initial Contact results, what color would be used by Ansys Mechanical to highlight a Bonded contact region that has a Far Open status? Select the best option.
CorrectIncorrect -
Question 7 of 10
7. Question
For Remote Points, which of the following statements hold true? Select the 2 best options.
CorrectIncorrect -
Question 8 of 10
8. Question
In Mechanical, when defining a Remote Point with deformable behaviour, which of the following boundary conditions should ideally be avoided on the pilot node of the Remote Point? Select the 2 best options.
CorrectIncorrect -
Question 9 of 10
9. Question
In Ansys Mechanical, how are "Connections" related to "Remote Points"? Select the best option.
CorrectIncorrect -
Question 10 of 10
10. Question
In a finite element analysis, in which scenarios are "Contact Regions" preferred over "Connections"? Select the best 2 options.
CorrectIncorrect